Make An Olympic Torch With Kids.
Make a Colorful Olympic Torch
With the Olympics nearly upon us, there’s no better time than now to get your family into the spirit of the games! This Olympic torch project is the perfect opportunity to have a crafty date with your kiddos while you teach a bit about the history of the torch, the games, and why you celebrate the incredible athletes who compete at the Olympics. It’s a fast and simple project that you’ll probably be able to put together using just the materials you have on-hand at home.
This is a project that you’ll be able to modify according to what you have on-hand. You can use a cardboard tube that you have in your craft supply, but you can also use an empty paper towel roll or toilet paper roll. In a pinch, you could even cut up a cereal box and roll it into a tube! Be creative and have fun.
Tissue paper in flame colors (red, orange, yellow, etc.)
Cut Paper Strips
Start by layering your tissue paper and cutting it into strips that are each about 8 inches tall and 20 inches wide. You’ll need two strips of each color to make the flames look nice and full. Cut carefully so that the rectangles are roughly the same size.
Shape into Flames
Using your scissors, cut flame shapes into one long side of the tissue paper. They should essentially look like a tall zigzag pattern cut into the top of the papers. Cut the flames so that they reach almost halfway down the 8-inch tall strip (about 3 to 4 inches deep). You can choose to cut the papers individually for a more randomized look or to stack the papers and cut them all together to save time (and cutting).
Layer and Tape
Neatly stack all of the tissue paper in a single stack, so that the sheets are slightly overlapping. Create the overlap at the bottom, so that you can see approximately 1/4 inch of each sheet sticking out from under the sheet on top of it. Use a few lengths of clear tape to affix the sheets of paper in this position.
Prep to Roll
Spread a line of glue dots along the bottom border of the tissue paper, over the area where you layered and taped. (If you don’t have glue dots, you can use school glue. Just be sure to allow for plenty of drying time.)
Roll the Flame
Start rolling the tissue paper in on itself, so that the color on the bottom of the stack becomes the outside of the roll. The roll should be loose and gentle so that you’re able to see all of the colors as they roll together. Don’t make it too tight or you won’t be able to fluff the tissue paper without it tearing.
Insert the Flame
Add a few glue dots around the base of the flame and insert it into the top of the tube, pressing the glue dots into the inner sides of the tube as you insert.
You can also use school glue for this step, spreading a thin layer on the inside of the top edge of the tube and affixing the paper there.
Be sure to leave ample drying time before moving on to the next steps.
Fluff the Paper
Use your hands to gently ruffle and fluff the tissue paper into a flame shape. Be careful not to rip as you separate the layers.